UNB ECE4253 Digital Communications
Department of Electrical and Computer Engineering - University of New Brunswick, Fredericton, NB, Canada

Polynomial Hardware Design

Provide the circuit parameters to design and to analyze modulo 2 divider and multiplier circuits.

Circuit Details

multiply by 1011 
Circuit for multiplication by: x3+x+1

OUT = A + C + D

Circuit and Data Input Parameters

Zero input = zero output. Provide a single bit 1 as input to observe the impulse response.

Serial Input (binary):
Circuit Taps (binary):
DIV MUL

* Start Over
Modulo 2 addition is shown schematically equivalent to Exclusive-OR gates.

2024-04-25 14:43:14 ADT
Last Updated: 05-11-16 		Richard Tervo [ tervo@unb.ca ] Back to the course homepage...